Is this O/C Safe , besides BSOD's what's the symptoms ?

[Richard_Cranium72]

Got a Socket 370 Biostar # M6TWC-810L ?

Put in a 366 ran it at 413,, thought, dam this thing is FAST..

Full Cold Boot in +/- 30sec

So, I put in my 533 Celery
Stock voltage
75mhz FSB
Intel Retail HS/Fan (which rates very good)

Thing boots and runs windowz fine,
have NO Temp sensor in windows, do in BIOS
109F after 20 min full load

Besides BSOD's or failure to POST what's the warning signs, any ?

BTW, just checked 25 second Cold Boot Time

[This message has been edited by Richard_Cranium72 (edited 06-08-2001).]

[Target]

BSOD's, failure to post, data corruption, lock-ups during application use, kernal errors caused by applications, etc. are the most common things.

[paul233]

If it is possible that it cools off a bit between when you close windows and check the bios temp, it may be getting a little hot, not sure, that would be a good temp for a AMD product, maybe a little hi for intel? Otherwise it seems quite good.

[Richard_Cranium72]

The alarm trip point on my IBM with a AMD K6-2 475 is 127F

The Celery finally showed it's colors and locked down tight while doing NOTHING..
Twice.

So down it comes to stock,, now where's that 366 again

The 366@75mhz FSB(413)is much quicker than the 533@66mhz FSB