Search:

Type: Posts; User: SEALTEAMTHREE

Page 1 of 31 1 2 3 4

Search: Search took 0.07 seconds.

  1. Replies
    10
    Views
    808

    Yeah, well, I get to jump out of airplanes, blow...

    Yeah, well, I get to jump out of airplanes, blow stuff up and use automatic weapons. I only use my computer during the nights and weekends. I think I have the best job on earth :D
  2. Replies
    11
    Views
    1,584

    Just more BS....lets make sure everything that...

    Just more BS....lets make sure everything that anyone types is 100% politically correct. Look at it this way: if someone asks a question about CD burners, then that thread should be deleted because...
  3. Replies
    15
    Views
    1,392

    Did you install the drivers? Also, make sure that...

    Did you install the drivers? Also, make sure that your wave balance is turned up and not muted. You could listen to a CD with wave balance muted but nothing else. Also check the in-game audio...
  4. Replies
    14
    Views
    904

    Jimstep: Question- How was your HSF drawing...

    Jimstep: Question-

    How was your HSF drawing hot air out of your horizontally mounted PSU? Is it really long and not too tall, or are you confusing horizontal and vertical? Horizontal is like this...
  5. Replies
    4
    Views
    649

    Since Intel is dropping Rambus for DDR, DDR is...

    Since Intel is dropping Rambus for DDR, DDR is the best choice. Frankly, it has always been the best choice because its cheaper than rambus, you only need 1 DIMM to use it (Rambus uses matched...
  6. Replies
    6
    Views
    1,438

    You should get at least 98 SE, or go for 2000. I...

    You should get at least 98 SE, or go for 2000. I can run my computer for weeks at a time without a shutdown and it runs very smoothly on 2k. I set it to suspend to RAM 1/2 hour after the screensaver...
  7. Replies
    9
    Views
    560

    Check to make sure the IDE cable is plugged in....

    Check to make sure the IDE cable is plugged in. Then check any other drive that it might be slaved/mastered to and make sure it's plugged in with both power and IDE. Then check the jumper...
  8. Replies
    2
    Views
    455

    Why would you want to? AMD put it there because...

    Why would you want to? AMD put it there because it protects the core in the same fashion a shim protects the core on an Athlon. Its been glued down pretty good, so you're probably not going to get it...
  9. Replies
    14
    Views
    904

    http://www.directron.com/s500p.html InWin S500...

    http://www.directron.com/s500p.html

    InWin S500 midtower features a horizontally mounted PSU and two fan mounts (one in the back, one in the front), a removeable harddrive cage, drive rails for two...
  10. Replies
    14
    Views
    904

    Hmmm lets see here....131 F is 55 C...you're...

    Hmmm lets see here....131 F is 55 C...you're running a little hot by my standards, but its nothing to be worried about. AMD says that safe maximum operating temperature is about 60-65 C, and burn out...
Results 1 to 10 of 310
Page 1 of 31 1 2 3 4