Help! how do i configure my additonal harddrive

[laser]

I have recently installed a PCI Raid Controller card to enable a 3rd IDE channel. My new harddrive is connected to this and set as Primary (G After installing windows it took primacy in booting, even when told in BIOS to use C: only. I was forced to remove the partition and leave the new drive unused to regain control of C:
Would I improve matters if I made the newer (larger)drive primary on IDE 0 and place the smaller drive on the raid card as secondary? I was thinking of partitioning and dual booting the larger drive and using the smaller drive as backup?

[SysOpt]

^ bump ^

[Mntsnow]

My question is Do you want to BOOT from the Raid card and are you wanting to use raid?

[This message has been edited by Mntsnow (edited 06-10-2001).]

[laser]

Admitedly I chose the wrong forum to post the question, maybe this has most to do with the delay. I had even forgotten about the post, but this being the first time to my knowledge of a reply it's not too surprising.
Fortunately I have discovered a real-time alternative to this forum, and with their help and some perseverance on my part all is well.