Setting's on pre Plug and Play?

[Hurt_Me_Not]

I've a couple of older preplug and play cards
that i don't have the setup disks for.
Is their anyway i can work out what they are set to at present?

I can get a new card for $25 just not going to Perth for a couple of weeks so any help would be nice.

[Symes]

If there are no obvious markings on the board for jumpers...

Search for the manufacturers web site and look for documentation?

Put them into a 'minimal configured' PC (only video and disk cards fitted) and run one of the diagnostic programs to see which IRQ and Addresses are in use (checkit or sandra will do it I think).

[Hurt_Me_Not]

Tried the first two but didn't think of the last one.

Thanks