Bridging using Cisco 2503

[Stan]

Hi

Need some help here...
We have a t1 connection between office A and offcie B. We are using cisco 2503 for bridging.
From a PC on the A end, I can ping a PC on the B end.
BUT, from the A end, I can NOT open a telnet on the router at the B end...

Any input much appreciated...

Stan

[Jin Vitas]

Dont forget to add the ip route to the other router.
Router (config)# ip route targetrouter_ipnetwork subnetmask targetBRIport_ipaddress

forgot to mention did you set a telnet password for remote access under line vty?


[This message has been edited by Jin Vitas (edited 04-23-99).]

[Stan]

Hi...

Thanks but the problem is solved...
The problem was the PC at the A end: faulty NIC... Aaaaaarghhhh

Thanks

Stan