question about abit bh6 mobo and defalut voltage

[vitamin e]

my abit bh6 has been flashed with firmware JJ and no the default voltage is set to 3.5 instead of 2.0..and ways to get get it back to 2.0 as default..tried flashing back to firware CN,, didit work

[bighammer]

how in gods name did you do that?
1st how did you get it that high before you flashed?
Now for fun, get the HN bios and flash the chip with NO helpers,
god, how do you get your system to boot?
anyway.
just type this in;awdflash BH6_HN.bin
that's all, NO switches.
should go back to original{2.0v}
or 2.8v if it's an early chip

[vitamin e]

my system boots..i just set the voltage manually to 2.0.....thanxs for the tip