PCCHIPS100 M747 Board

[norm]

Anyone had xperience with o/clock 333 celeron with this board (on board sound & video) also am looking for a good 3d board if the m/board can take one (PCCHIPS site not very helpful)any advice appreciated

[Isos]

I have no experience using this particular motherboard. I am using BH6 for overclocking slot 1 cpu.

As far as I can see in the jumper settings for the M747, the user is only given 66 or 100 MHz FSB. Since the multiplier of your 333 is most likely lock at 5.0, the only option left for you is to try 100 FSB. At least for board version 1.3 board version is found on the right corner near the keyboard connector

Look at the FSB jumper selection, it uses four jumpers but you need to move only one to change between 66 or 100. I wonder what's the use/effect of changing the other 3. Of course, THAT IS VERY DANGEROUS - you might FRY YOUR CPU.

I WILL NOT BE RESPONSIBLE FOR ANY DAMAGE TO YOUR SYSTEM.

Here's a link to the M747 jumper settings
www.pcchips.com/m747jp.html

Good Luck

[This message has been edited by Isos (edited 02-10-99).]