Voltage setting on celeron 500MHz?

[gene1938]

I picked up a new MB-A-Bit BP6. What voltage should I start at for the CPU? Celeron 500MHz @66fsb. It is set to default @ 2.00 volts. tHANKS -GENE

[a Bill]

Well, your at the reccomended voltage now. What did you want to use? The BIOS may let you up the voltage if needed but if the CPU is operating fine at default, then leave it there, it'll run cooler.

[gene1938]

cool-I won't fix it-if its not broke. THANKS for the info, just wanted to make sure it was right-gene

[a Bill]

It's always good to double check

[gene1938]

If 2 volts is default- can I lower it (in hopes of lower temp), until system becomes unstable?? thanks-gene

[mnx]

yeah you can lower it, in hopes of lower temps...

mnx