300a/BH6 450 @2.3v?

[MrLuigi]

Anyone have any problems running 300a @2.3v
Seems the only way to get it stable at 450.
can't get 464, (malay-compeq 1/99 SL2WM),
other chip malay-clover 12/98 runs 2.0v @464 no problem, also SL2WM.
both seem to run at around 30c to 32c,
both using FAB12 heatsink/2fans/thermal goo.
both on GY ver. BH6's, 6ns PC-100 64mb
both HD's set to mode 3, ecc-off (bios),
error hold off (bios).
Need feedback please

[Isos]

Just make sure you have a good cooling in your case (air flow) Too much heat will reduced the lifetime of the parts. Later on, try to reduced voltage one notch - if it works, you can enjoy it longer. Otherwise, that's what OC is all about. Finding a setting that allows the cpu to run over the specs it is being marketed. Consider yourself lucky - others have problem running it stable at that speed.