-
Running the Via KL133 at 133
Hi
I have one of the new Asus AVL-VM boards based on the KL133, which apparently only goes to 100 Mhz. However, J1 does have a 133 Mhz setting, which I'm not really sure works. If I put it to 133, will I fry the mobo/CPU/chipset/RAM? And will I get the theoretical 997 Mhz? I'll also appreciate cooling solutions, I'm not sure the current h/s and fan can take it, they;re already running at 52/53 celsius...
I'm running a Duron 750 with 256 megs of 133 capable RAM, and an ATA-66 7200 RPM 8 GB drive (hell, it was hot technology two years back...)
Thanks in advance,
Sang
-
Member
You can try it. The worse that can happen is that the system wont boot. That board has a jumper free mode, correct? Useing that feature will make it much easier to O/C. The TaiSol CGK760092 and ThermalRight SK6 are great coolers that don't cost an arm and a leg. Have a look at the Heatsink Factory .
[This message has been edited by Atomic Rooster (edited 08-22-2001).]
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|