Have a PCI Controller Card SATA, IDE, RAID for my winxp, later win7-PC.
its Mod.-Nr. 19739/20140922SZ009 by CSL germany.
NB: Sata-slots on card are wrongly specified in jumper-table CN2 is confused with CN3, wrongly named on card.

Driver is installed. i had choices. older were also available so i took newest. no information in the sheet.
They also do not tell that admin.right are needed.
Choises are:

A. Internal SATA Port CN3 + External SATA-Port/eSATA CN2

B. Internal SATA Port CN1 + Internal SATA-Port CN3

Actual jumpering is for A. using external esata-slot.
Maybe its wrong thinking:
i connected internal SATA-drive to the internal slot, esata is empty - I DONT SEE this drive
I will now change jumpering in verify.
so temporary using choice B.

Maybe i must connect pc-card with internal sata-slot and use drive externally?
i will wait until an answer is coming. Thanks a lot