Results 1 to 2 of 2

Thread: Adding Thermal Grease to Arctic FreezerA11 or CPU?

  1. #1
    Ultimate Member
    Join Date
    Jul 2001
    Location
    Basel-Switzerland
    Posts
    4,100

    Adding Thermal Grease to Arctic FreezerA11 or CPU?

    The Arctic Freezer A11 is a huge freezer with an intelligent pipesystem.
    the drawing shows the three flat parallel-pipes which are in contact with cpu.

    since i didnt understand i added greast to full cpu-surface the normal way. keeping it very thin. but in the drawing grease should be added on these pipes.
    since i received the freezer used it could be that there was a protection on that surface.
    they show to use only half of the surface(widht) for thermal grease.
    Should i start all over again since grease is on full surface of my amd phenomII 955?
    www.stereopan.org
    underreconstruction
    3Daeropanorama
    was: 3DMarspanoramas
    3DVideos
    www.3dmedia.ch
    www.3dmusic.ch

  2. #2
    Lifetime Friend of Staff
    Join Date
    May 2007
    Location
    Sheboygan, WI
    Posts
    3,921

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •