-
Ultimate Member
How To Connect A IDE Drive To Sata Board
Hey Yall,
Setting up a new Computer...I have the hard drive and DVD connected to the only IDE slot. I want to install my (IDE) internal hard drive enclosure and (IDE) CD drive to SATA. I have the two adapters (IDE to Sata). Are there any drive settings or bios settings I need to be aware of? XP Home OS and a GIGABYTE GA-P35-DS3R Mother Board.
Thanks,
Baddog
Improvise - Adapt - Overcome
SafeSearch is off
-
Ultimate Member
Your mobo either came with a floppy that has the SATA drivers, or you can make one by thoroughly reading your manual that can be found here - start on page 72
once you've setup your BIOS properly and when installing XP early on at the prompt press F6 to install scsi raid drivers - nothing will happen then but later on it will ask you later to put in the floppy.
The install should continue - if you get to a point where it still doesn't see the HDD - exit setup and try again
That's assuming you are in fact installing a SATA drive. If you're simply plugging an IDE drive into a SATA capable board normally in the BIOS you'll find something to disable the RAID/AHCI/SATA settings. Hope this helps - post back if I'm off the mark.
"hope to someday have a clever or inspirational quote....."
ANON
-
Ultimate Member
Originally Posted by Baddog
...I have the two adapters (IDE to Sata). Are there any drive settings or bios settings I need to be aware of?...
Jumpers vary between drives , so you need to read the doc's or use the trial n error method. If the drive still wont POST, then try disabling Quick POST to give the drive time to spinup with your fast board.
-
The IDE to SATA adaptors i have, you pretty much configure the drive jumpers as you woudl if they were ot be the IDE Master drive then plug em in and your away.
They may not all be alike though
--Jakk
"You don't know Jakk..."
Windows Vista Business x64
Hiper 580Watt PSU -- Gigabyte GA-P31-DS3L -- Intel Core2Quad 6600 -- 4GB PC6400 -- 256MB GeForce FX7800GT
SATA-II HDD 1x500Gb/1x400GB/1x250GB-- 1x120GB ATA-100 HDD[/B]
-
Ultimate Member
I have all my software loaded back on my IDE Hard drive with the OS. Going to hook up the IDE DVD and Cd Drives tonight on the SATA plug ins tonight. I'll let you know how it goes....
Improvise - Adapt - Overcome
SafeSearch is off
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|