dcsimg

Search:

Type: Posts; User: Fluffy_624

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    863

    I'll get him to look for that tomorrow. He has...

    I'll get him to look for that tomorrow.
    He has been able to get it to boot since then. It could see everything fine in bios and booted into windows. At this point installed the sound drivers for the...
  2. Replies
    3
    Views
    863

    Dying BIOS/motherboard?

    Having problems trying to troubleshoot my brothers pc over the phone from 130 miles away.
    It started with Half Life 2 crashing which their tech support people tracked down to the sblive sound card....
  3. What multi are you running with atm? You could...

    What multi are you running with atm? You could put the cpu voltage up a bit. Anything up to 1.7v is fine with decent cooling. The ram timings look fine. Never had a chance to play with decent fast...
  4. Replies
    4
    Views
    782

    I just left the memory as it was. I have it...

    I just left the memory as it was. I have it running at stock 9800pro speeds(380/675) as my monitor refresh rate drops to 60hz at anything over 1024x768. At that res i can run any game with max...
  5. Replies
    2
    Views
    680

    The cpu has been overclocked since i bought...

    The cpu has been overclocked since i bought it.(Highest has been 15.5x166) The ram i've had since i had an xp2400+ at 13x166 and has been well and truely burnt in at that speed by over a year of...
  6. Replies
    2
    Views
    680

    Only taken 3 months but i did it!

    Woo Hoo. Finally. Its only taken 3 months of tweaking and burn in but i have my 1 gig of old, not very o/cable crucial pc2700 running at pc3200 and 2.5-3-3-7. It took a month of running at 100% load...
  7. Replies
    4
    Views
    782

    I have the same sapphire 9800np flashed to pro...

    I have the same sapphire 9800np flashed to pro with 3.3ns ram and an arctic cooling rev.3 silencer on it. The fastest i have managed to get it running was 440/745. However there was some artifacts...
  8. Replies
    18
    Views
    2,017

    With the board you have i would go for the...

    With the board you have i would go for the passive one just for noise reasons. It's not really high enough performance to need an active cooling solution.
  9. Replies
    8
    Views
    1,325

    Sempron PR ratings are supposed to compare to...

    Sempron PR ratings are supposed to compare to Intel celeron speeds not p4 speeds.
  10. Replies
    18
    Views
    2,017

    The 2 screws are what holds the fan onto the...

    The 2 screws are what holds the fan onto the heatsink. To remove the heatsink you need to remove the mobo from the case and pop the other 2 plastic pins thru from the other side.
Results 1 to 10 of 74
Page 1 of 8 1 2 3 4