Search:
Type: Posts; User: Butte
Search:
Search took 0.05 seconds.
-
I have been reading these posts for while this morning for about an hour this morning.
I bought a new G400Max and then remembered that I don't have an AGP port on my mother board. Not real bright...
-
All the 590 Mother boards I have used run at 100 Mhz if it has a 350 or faster CPU installed. I have one running om my network and it runs fine. I do have to admit I haven't benchmarked it to see...
-
Did you try "removing" the modem while you were in the device manager? Just curious.
Mark
-
.
[This message has been edited by Butte (edited 05-15-99).]
-
I have an Alton 598 with a 400 and it was set at 2.3 volts till I set it at 2.5, for overclocking reasons. I noticed on PCChips sight that this is a bios error on this board and it is due for a fix....
-
You have to be careful shopping on Price Watch. Some of the vendors their will rape you with high shipping charges. I payed $47.00 shipping on 2 keyboards and 3 mice once. Just make sure you check...
-
Let me settle this argument, ALL HARD DRIVES SUCK. Seriously tho. I have had Maxtor and was happy with them and I have had seagate and was happy with them and I have had Samsung and was happy with...
-
I run a 598 with a 400 chip at 450, clock at 4.5 and the bus at 100, and it runs more stable than it does with the CPU set for a 400. I run Windows 98 without any problems. I think you might have a...
-
Show, it doesn't have any effect on windows 95 or 98. It gives the CPU the juice it needs to run at the faster speed but doesn't effect windows. The CPU needs a higher voltage to run faster. I had...
-
Sounds like you havean Alton 590 or a PCChips 5090. Same board. You disable the video in the bios.
Good luck,
Mark
|
|