Kurylo
01-29-2002, 04:13 PM
Where do the signals (monitoring, +12V, ground) go in the standart 3-pin HSF?
I know, that groung goes directly to the PC case. But where the +12V go from? The resistance between +12V DC in the HSF and +12V DC ATX power connector is almost 200 Ohm !!!
And the same question about the monitoring connector of the HSF...
What microscheme exactly 'eats' this data, and where I can find it? I suspect that there are three of them working independently (for CPU, AUX and SYS).
I know, that groung goes directly to the PC case. But where the +12V go from? The resistance between +12V DC in the HSF and +12V DC ATX power connector is almost 200 Ohm !!!
And the same question about the monitoring connector of the HSF...
What microscheme exactly 'eats' this data, and where I can find it? I suspect that there are three of them working independently (for CPU, AUX and SYS).