TechMedia manual

[Callas]

Just bought a barbones Tech Media PC. It has no manual. Can't access Tech Media web site. Would appreciate any an all advise regarding this Korean brand. Box says that this is a TC PA 1000. Can't find any model no. on MB.

[quidne]

Hi Callas,I`m a newbe to PC`s but these may help. pcmech.com , tomshardware.com , mcp.com and zdnet.com I hope this helps. Quidne@hotmail.com

[jayzad]

callas here are the direct links to the sites quidne mentioned http://www.sysopt.com/forum/smile.gif

pcmech.com (http://pcmech.com)
tomshardware.com (http://tomshardware.com)
zdnet.com (http://zdnet.com)
mcp.com (http://mcp.com)

Who did you buy your computer from.??


[This message has been edited by jayzad (edited 06-21-99).]

[Callas]

Thanks for the input guys. My problem is that I bought 4 of these cases w/motherboard, but none of them had a manual. The company's web site is down and the phone no's I have, just leave you on hold. No help there. Also, I can't find any help for this brand on the help sites. The cases look great, but I don't have a starting place to get them set up. I got them on uBid Auction and I'm in contact with them about some help. Wish me luck.

[jayzad]

Callas What is their web address url. So we might go there when it back up. It will help to see what you have. Give us more information 8086,8808,286,386,486......
Thanks http://www.sysopt.com/forum/smile.gif

[Callas]

Thanks for all the tips and suggestions, gang. I FINALLY GOT SOME HELP. I guess the mfg. is going out of business, but at least I was able to get the jumper settings from the firm that put them up for auction. They're limited to Pentium 200, unless I can upgrade the Award BIOS, which doesn't seem likely at this point. Too bad... the cases are beautiful, and it's ATX. If you have any further suggestions, LMK ...thanks again.

[kccottrill]

Callas, Where did you get the manual info for the techmedia computer that you have. A friend asked me to look at one that the hard drive was trashed on, and to make a long story short, the critter won't even show any video now. Any info would be appreciated.

[Callas]

Hey... kccottrill! If you got one of these, you need help. I'll send you everything I have, including tips if you'll send me an email to: callas@arn.net. In the meantime, understand that you can't go higher than a P233 cpu, and you can only use EDO simm memory... no dimm. The jumpers for the P233 mush be set the same as a P100. I have the jumper settings. They can be made to work.