Strat 1
08-21-2000, 05:14 AM
My Computer will recognizes only 1/3 of the added memory
I just dropped a 64 MB Dimm into a Compaq 200 MHz, The computer originality had a 32 MB and I added a second Dimm (64 MB) so I should be at a total of 96 MB. But the commuter only reads 49 MB
What is going on?
When I put the new (64 MB) Dimm in ONLY, it reads 32MB-
it reads 49MB with the new 64 and old 32 MB
reads 32 with old stick only
That would totally suck if this Mother board was only able to see 49 MB, are there any jumper settings on the Board that would change that? There must be some way to make this board see all the Memory.
Thank god this is not my computer or I would have thrown it out the window a while ago--
I just dropped a 64 MB Dimm into a Compaq 200 MHz, The computer originality had a 32 MB and I added a second Dimm (64 MB) so I should be at a total of 96 MB. But the commuter only reads 49 MB
What is going on?
When I put the new (64 MB) Dimm in ONLY, it reads 32MB-
it reads 49MB with the new 64 and old 32 MB
reads 32 with old stick only
That would totally suck if this Mother board was only able to see 49 MB, are there any jumper settings on the Board that would change that? There must be some way to make this board see all the Memory.
Thank god this is not my computer or I would have thrown it out the window a while ago--