qball
07-16-2001, 10:53 AM
Fairly useless post.
Win98, FAT boot, NTFS and FAT32 partition.
For awhile, I was getting a "divide by zero" error trying to run Partition Magic 5. Had always worked before and had performed so partition stuff flawlessly. Since my partitions are basically in stone until something bad this ways comes, I wasn't very concerned.
Anyway, I ran scandisk and defrag. When finished (in safe mode) PM5 worked (640X480 sucks). So I rebooted and same "divide by zero". So I went one by one through Close Program dialog checking PM5 each time until only explorer and systray were left. Still got "divide by zero". Mentioned to the inner circle and nothing. Searched the web somewhat, nothing.
Tried PM5 today, worked just fine. Anybody shared this experience?
Win98, FAT boot, NTFS and FAT32 partition.
For awhile, I was getting a "divide by zero" error trying to run Partition Magic 5. Had always worked before and had performed so partition stuff flawlessly. Since my partitions are basically in stone until something bad this ways comes, I wasn't very concerned.
Anyway, I ran scandisk and defrag. When finished (in safe mode) PM5 worked (640X480 sucks). So I rebooted and same "divide by zero". So I went one by one through Close Program dialog checking PM5 each time until only explorer and systray were left. Still got "divide by zero". Mentioned to the inner circle and nothing. Searched the web somewhat, nothing.
Tried PM5 today, worked just fine. Anybody shared this experience?