//flex table opened by JP
PDA

Click to See Complete Forum and Search --> : Memory settings for kt7-RAID

ThiemeMD
04-10-2001, 05:32 PM
Also, In your "SoftMenu III" panel in BIOS, set your DRAM CLOCK to HLCK+PCICLK.
This will run your memory at 133mhz instead of 100mhz.
Set "Enhance Chip Performance" to "Enabled"
Set "Enable DRAM 4K Page Mode" to "Enabled".
This combined with the tweaks above should get you 525-550/575-600 ALU/FPU.

Good Luck!

ThiemeMD


[This message has been edited by ThiemeMD (edited 04-10-2001).]
fishpro619
04-11-2001, 01:27 AM
I have a 1 gig thunderbird and pc133 256megs and was wondering if anyone has some optimal settings. Im getting alu is at 395 and fpu is at 438. Occording to sisoft. And recomendations would be great!
AuraEdge
04-11-2001, 01:41 AM
Optimal is Turbo on all 3 banks, CAS2, and 4 way interleaving.
CAS2 may not work on all memory chips, but Turbo and interleaving will work on about all of em.