SIS MOTHERBOARD QUESTION [Archive]

SYRiiS

01-24-2001, 05:51 AM

I JUST DECIDED TO COMPILE ALL OF MY SPARE PARTS TO MAKE A CRASH SYSTEM. (ONE I CAN CONTAMINATE VIA VIRII TO VIEW EFFECTS) ALL WENT TOGETHER WELL, BUT "AND I FELL LIKE A REAL CLOWN ASKING THIS" I CANT FIGURE OUT WHICH WIRES GO WHERE IN REFERENCE TO THE POWER SWITCH, HD LED SWITCH, ECT.... I HAVE LOOKED FOR THE SCHEMATICS, BUT HAVE NOT BEEN SUCCESSFUL... ANY HELP WOULD BE HIGHLY APPRECIATED!

IT IS AN (SIS) BOARD, WITH A SIS 530 PC100 CHIPSET... ALL I NEED IS TO POWER THE DARN THING UP,,, IM ALL GOOD FROM THERE...

Bsdboy

01-24-2001, 06:04 AM

Did you look at the board? it should be
screened on there someware.Sometimes it's
not anywhere near the header but it is
usually there.If you need more help please
give more info:manufacturer,model #
Here is a list of boards that use the 530
maybe yours is listed here http://www.sis.com.tw/products/530cus.htm

[This message has been edited by Bsdboy (edited 01-24-2001).]

[This message has been edited by Bsdboy (edited 01-24-2001).]