overclocking a 433 celery on an abit bx6 r2

[j03y]

I have been trying to overclock my 433 celeron with no success. Each time I bump up the bus speed, and reboot my computer, the startup bios notes the new speed and then spits back the following error: "the CPU is unworkable or has been changed, check the soft menu to check configuration." Then I have to reboot again and the bios cuts the chip speed to 233(66). Obviously, when I leave it at 433(66) it runs fine. How can I get it to take the new speed?

[Mntsnow]

In your CPU section of the bios just toggle the option on "speed error hold" and you will be off to the races http://sysopt.earthweb.com/forum/smile.gif