CraweN2k
05-19-2000, 04:24 PM
Hello all.
I have recently flashed my bios, from revision 1011 to 1012. But after restarting, my monitor was blank as hell. I know for sure, that it was the right rom file I flashed the bios with.
Anyway, I decided to try an reset my bios, hoping this could solve the problems with the screen. As I skimmed through the manual, I noticed that in order to reset the bios, i had to shorten the solders. Anyway I'm a little bit unsure as to how this is done. Should i take a wire and connect the 2 solders and then turn the power on, or is the solution something completely else?
I would appriciate some feedback, since I'm a bit stuck.
Thxs in advance
Thomas "CraweN" Martinussen
I have recently flashed my bios, from revision 1011 to 1012. But after restarting, my monitor was blank as hell. I know for sure, that it was the right rom file I flashed the bios with.
Anyway, I decided to try an reset my bios, hoping this could solve the problems with the screen. As I skimmed through the manual, I noticed that in order to reset the bios, i had to shorten the solders. Anyway I'm a little bit unsure as to how this is done. Should i take a wire and connect the 2 solders and then turn the power on, or is the solution something completely else?
I would appriciate some feedback, since I'm a bit stuck.
Thxs in advance
Thomas "CraweN" Martinussen