Again Abit BE6-II blue screens

[ricardo013]

Can anybody explain me why after upgrading
my M/B for Abit BE6-II my Linux RH6.1
works perfectly like before and Win98 (also
SE) can not even complete setup with
minimum configuration (I removed Diamond
Monster MX300 and CD-ROM, disabled UDMA/66
and floppy) but only "blue screens" appear
after Win finds any of devices.
I flashed today new BIOS -QJ but same result.

[Kruppt]

Go to this Newsgroup and ask that Question, it is an IRQ problem,(IRQ SHARING) but I'm not that versed in the issue of solving the problem for you but I can steer you to some geeks that can. news://216.242.22.54/
Post your problem there as a lot of Abit overclockers and people who are familiar with Abit IRQ issues are on this board.

[ricardo013]

The only solution I found for my MoBo
was to shift my harddisk to IDE3 channel
(UDMA66) and installed Win98 - w/out any errors. Then I shifted drive back to IDE1
(DMA33). I need this b'cause I mainly work
on Linux n last stable kernel does not support HPT366 controller.
One bad thing is that it is impossible
to install any of devices with HDD on IDE1-2
as Win98 setup program hangs OS immediately