HOT591P Problem

[DBFerret]

I have a HOT591P motherboard.
Bios Award 4.52
Bios date 8/2/99
64Meg RAM
CPU: K6-2 333Mhz
Clock settings 3.5X95

Situation:
Jumpers have been checked by me and another computer geek. Question: According to the manual current jumper settings should read as above. CPU Multiplier 3.5, FBS 95Mhz, Memory Clk Speed 100Mhz.

Quandry:
Sisoft Sandra utilities are reading the the FBS @67Mhz and the multiplier @ 5X. If I remove the jumper and move the FBS to 100Mhz, not touching the jumper effecting multiplier speed or memory speed, Sisoft Sandra correctly reads the settings as FBS 100Mhz and Multiplier @ 3.5 and memory speed @ 100Mhz.

Question:
What gives? Is Sandra misreading the settings, or is the manual wrong. Or is there a problem with the motherboard?

Any help would be appreciated.

dbferret@earthlink.net

[scotter]

check shuttles web site for a updated manual just to make sure and any othere updates for your mobo
but sandra can be wrong and miss reads a lot of stuff anything and every thing sandra says should be taken with a grain of salt http://www.sysopt.com/forum/smile.gif

sandra is probably getting confussed becouse your running your Fsb and memery at 2 diff speeds.

othere than that I dont know a about that mobo but I hope I helped a little http://www.sysopt.com/forum/smile.gif

[This message has been edited by scotter (edited 03-02-2000).]

[DBFerret]

Appreciate the response. However I forgot to list the Sandra is also reading the memory speed at 67mHz with the jumper inplace and 100Mhz without the jumper. What makes this strange is I am NOT touching the Memory jumper, but Sandra reads a change in memory speed.