//flex table opened by JP
PDA

Click to See Complete Forum and Search --> : BE6, Highpoint Annoyance

jooksingjai
02-14-2000, 10:46 PM
I have a BE6 with 128mb ram and a PIII 550.
My question is, how can i get rid of the screen for highpoint at startup? It is pretty annoying since I have opted to run on the regular ide coz the ata66 is making my computer freeze up.
Nomjr
02-14-2000, 11:42 PM
I had the same problem with my BE6 2. In the bios there is an option to disable the Ultra 66 support. I disabled it and it quit posting the message. Hope that helps?

Romy
jooksingjai
02-15-2000, 02:25 AM
No such luck, my BE6 doesn't have that in the bios unless I am not looking in the right place. What was yours under?
tlwhite76
02-15-2000, 07:11 AM
Is your hard drive recognized in the BIOS as a regular EIDE device and/or is your HD plugged into the regular EIDE controllers vice the ATA66 ones?
jooksingjai
02-15-2000, 10:26 PM
the harddrive can run at ata66 but i've been having too many problems with that setup so now i have nothing connected to my ata66 IDE's. The Harddrive is plugged into the regular ata33 ide.
Colonel Casio
02-17-2000, 10:17 AM
Sounds like you do not have your Highpoint device drivers installed or installed properly. I struggled getting those drivers installed until a nice online person showed me the way.
arn
02-17-2000, 09:54 PM
Its a burger to get the drivers installed, follow the manual carefully and enjoy the speed increase.

arn