PIII 533B with Abit BE6

[jooksingjai]

I have a Abit BE6 board and recently picked up a PIII 533B and PC133 SDRAM 128mb. I need to manually set the softmenu because the board doesn't recognize it. Can somebody help me out for the settings:
Ext. Clock = ???MHz
Multiplier factor = x???
AGPCLK/CPUCLK = ???
L2 cache latency = ???

I would like to be running at 533MHz or 550Mhz. Either that or minimum be running at 500MHz. Any help would be greatly appreciated.

Thanks,
Jooksingjai

[This message has been edited by jooksingjai (edited 01-30-2000).]

[alpha]

Sorry to break it to you, but you probably ain't gonna have much sucess. The cumine needs 1.65/1.6 volts, and I'm not sure if you can select that.
You can't run the chip at 550 because it's multiplyer locked. Unless you're video card is a voodoo3 with a fan or a geforce, it ain't gonna tolerate the high AGP clock brought on by the 133mhz FSB. You're harddrive will need to have UDMA disabled and PIO mode 3/4. You may fry your sound card and/or modem or network card.

The L2 latency should be around 2-5.

Sorry 'bout that http://www.sysopt.com/forum/frown.gif