Tekram P6Pro-A+ OC setup ?

[bambam]

I bought one of these mobos , a Tekram slotket (it has adj voltage but only 66,100,133mhz jumpers ), and Celeron 366(w/cooling). I am confused about the overclocking setup for the Celeron (ie how can I get 75,83 mhz bus speeds ?) Could someone who has done the Celron overcloking setup with one of these motherboards walk me through this (all this is new to new)

- Thanks

[GVolosky]

You won't get 75 or 83 if you can't set the jumpers your best bet is to set it up at 4 times 100mhz or 3 times 133 and try to get to 400 that way...
G

[bambam]

Darn it -That's what I was afraid of (no 75,83 mhz - that retailer's advertisement was very confusing-maybe even deceiving)

Since I only have 100 mhz SDRAM does this mean my only choice is 4 X 100 ?


Thanks

[RobRich]

The Celeron 366 has a locked mutliplier of 5.5 It can't be changed, so you must manipulate the FSB. Most Cel366's will make 550 with little effort. Try 5.5x100. This should give you an excellent performing setup. For more detailed info, read this:

ftp://ftp.tekram.com/documentation/p6proaplus/P6PROAP_INST_101.PDF

[bambam]

A few more questions - (My processor hasn't arrive from UPS yet but mobo&slotket have)

The manual shows a " CPU/PCI speed " BIOS setting with a warning about overclocking ).
Should I set the slotket jumpers to 100mhz then futher set the BIOS CPU/PCI
speed setting(from default speed to what #?)?

Also, what will happen if I use a PCI video card instead of AGP ( I already have a 3fx Voodo V2 1000 PCI)with respect to changing the FSB to 100mhz and/or adjusting this " CPU/PCI setting" ) ?


Thanks