112/124 MHz bus speeds on FIC 503+

[moto]

Can somebody tell me how to enable these two bus speeds? I can't find any information on this anywhere.

Thanks.

[Bleeding Edge]

Don't know anything about this board but bus speeds are usually changed in the bios.

[moto]

This board doesn't have softmenu or anything equivalent. The bus speeds are definitely jumper controlled.

[Gustavus Simmons]

I don't remember their URL, but Giga Corp maintains a site with detailed jumper settings for overclocking the FIC VA503+. Back when I was overclocking one of these MBs, I used their data with perfect results.
There is also a very good and reliable 9 page detailed instruction sheet at TC Computers -- from whom I bought a couple of the 503's. Look in Fast Eddy's subpage at TC. Good luck.

[Paulo]

FIC url is www.fica.com
http://www.sysopt.com/forum/smile.gif

[hitman]

I was doing research on my 503+ and found this site, check it out www.ginko.de/user/kkramer/503+.htm


[This message has been edited by hitman (edited 04-07-99).]

[jokostel]

here are the buss speeds they dont tell ya about for the VA 503+ :>>
112mhz FSB= CLK1 1-2 CLK2 2-3 CLK3 2-3
124MHZ FSB= CLK1 2-3 CLK2 1-2 CLK3 1-2
***ON MY FIC VA503+(W/AMD K6 300 .25MICRON VER I HAVE IT AT 112X3 WITH NO PROBLEMS)
I HAVE TRIED 124MHZ FSB BUT IT WONT POST.....
GOOD LUCK.....
jokostel@usa.net