keeping my duron unlocked and direct watercooling

[mnx]

I just siliconed over the l1 bridges after I unlocked them with a 6B pencil, so I could directly watercool the processor. It's workin great except my processor is no longer unlocked... =( ambient 21, water 22, cpu 25C 1.6V, 735MHz (100% load duron 700) any ideas to keep it unlocked so I won't run into this when I rip the pvc endcap off my processor, scrape all the silicone off and try again?

mnx

[paul233]

Rear window defogger repair paint, about 7-8$ at an auto supply store. Use a fine needle or a single bristle to put it on.

[Atomic Rooster]

A conductive pen works well also.

[Szech]

The conductive pen works, but it wears off like pencils do over time. I would recommend either soldering it, or using the rear window defogging goop. Both are quite permanent.

Out of curiosity, you have the water running right over the processor? Did you cover the other connects? Or are you simply using a non-conductive mixture?

[mnx]

I covered everything with silicone but to my suprise when I pulled it apart I found that where the L1 birdges were the silicone had come off... I tried it again and it still doesn't work guess I'll need to get some of that rear window defogger repair paint... oh yeah, I'm using distilled water (from a de-humidifier) so if it stays pure it shouldn't conduct electricity...

mnx