jumper settings HOT-637A V2.2 MoBo

[tecrekka]

My current settings are 2-4 5-3. I do not see this represented any where. All the possible settings I have found do not reflect this. Is this a neutral setting? the diagrams I have seen show the setting for 66mhz (where I am running) with no jumpers. Is this setting just to reatain the jumpers? Also, I am wanting to clock my i440lx at 4x75, just to verify, would this be the 3-4 jumper setting? Thank you in advance.

[torskdoc]

http://www.spacewalker.com/english/support/faq/faq.htm

go to motherboard jumper settings, look for your board in the pull downs. You'll see HOT 637 but not "A" version. on the 637 page you'll get two links....click on 637 V2.2

All the jumper settings are there.

You'd really be pushing the PCI bus if ya go 75 and at 83 you more than likely will not get a boot.

What chip are you running???

you might be better off working the multiplier instead of the FSB.

Larry

[tecrekka]

my chip is a Pentium II 266mhz, I'm not sure off hand what my FSB is on it but I know I got the info somewhere. I've heard of people o/c these to 300 without any major probs. Im using Arctic Silver and 2 hi-po fans. Where are the jumpers for the multiplier? Can I go 50mhz x 6?

[This message has been edited by tecrekka (edited 01-26-2001).]

[This message has been edited by tecrekka (edited 01-26-2001).]