anyone had success burning in a duron chip?

[tcul72]

i can get my 650 up to 950 if i up the voltage as far as my m/b(asus a7v) will allow. this kind of scares me though. it seems stable but i don't know about the 1.85 voltage(asus probe says 1.92) if i run it at this voltage for a few days, then try and drop the voltage do you think it'll be okay? or is 1.85 volts okay for the durons?

[werd]

lower the speed down past 650, then give the processor some juice. run some processor intensive proggys for a while. after about a week you should be able to go higher with use of less voltage.

I would set the voltage about 1.7v or so and drop the processor speed as low as allowable.

besides 1.85v shouldnt hurt these chips, the one thing that kills-em is the heat