CPU specs

[Maerjyon]

I have an Abit ZM6 motherboard and a Celeron 500Mhz processor... could anybody please help me with the proper settings (not overclocked though) for this. Right now, when I power up, I get a non-critical error message about my CPU not being set up correctly, and that I need to reset it, I've tried 500(66) but that just isn't working for me, I get the same message... should I change the voltage or something?

[BBA]

Turn off the hold on speed error in soft fsb and set to hold on no errors (all in bios).

(BBA)

[AuraEdge]

Yeha I think it may have an old BIOS that doesnt support it, so just shut off the hold error, and itll letcha pass. If your not overclocking, leave the volts alone!

[Maerjyon]

Thanks a lot. From the looks of Abit's website, they fastest they officially support with the BIOS is 466Mhz. I'm going to be upgrading my current BIOS soon though, just whenever I have an opportunity. Thanks again.

[chad174]

well you could flash the bios instead of totally upgrading it, just afile and a couple of commands will do it..

[Exacerbateman]

I have an Abit LX-6 and it worked for me, that is turning of "speed error hold".

Exacerbateman