Problem With a Slocket?

[KRAMER]

I just recently got an ABIT BH6 with a PPGA Celeron, and periodically the darn thing won't boot. All I get is NO SIGNAL INPUT on the screen. If I press on the slocket and make sure it is seated, it will boot. Is this a common problem with converter boards? Any suggestions to help keep it seated probably?

Thanks

[Anakhonda]

Would duct tape work?

I think maybe you just have a poopy adapter if you're having problems keeping it in the slot1. I've been running a 400Mhz Celeron with a slot 1 adapter, and it's a perfectly tight fit. If you're interested, I ordered my adapter from Spartan Technologies.

[1eyedjak]

May depend on the type of adapter you have. Did you get a namebrand or a gneric?

I have a MS6163 motherboard with a MS6905 slotket adapter and have never had a problem. Maybe that is because they were made by same company to go together.

just my .02