over-clock PII 333 on an Abit bh6 board?

[Sky]

I'd like to get my PII 333 cpu running at 100mhz bus. Right now i can only get up to 83 for a 416mhz. I'd like to use the 100mhz bus speed. Do I have to cover pin B21 on the cpu contacts?

[gERONIMo]

does it boot? post? get to windows screen then stop? let us know a little more info

[Dominus]

Whats the S-Spec? Week? Plant? Any other information you could give would be helpful.

[This message has been edited by Dominus (edited 05-20-99).]

[Sky]

here are the markings;
80523PX333512 SL2S5

It runs fine at 416mhz but after a few months, after running a while, the screens starts to black out for a few seconds or lines will run up and down. Might be the video card (Diamond Stealth G460)

It won't even get past post at 100mhz.

[BBA]

You probably will need at least 2.3 volts to do 500, mine did. I could do 416 for a short while only but 500 runs great, once I bumped up the volts.

BBA

[Dominus]

I agree with BBA. 500, or maybe 560 (don't get your hopes up) should be possible with 2.3v

Make sure you have adequete cooling! A VEK12 or VEK18 would be ideal.

[Sky]

thanks for the suggestions and input!!!