83mhz!!!

[MagnumJoe]

I have a Celeron 333, as to date I've been successful overclocking at 83mhz for 2 weeks now. When I run "sandra", it says to lower pci and apg speed ( bus speed it too high reduce FSB speed.) But I really haven't had any problems and the temp stays around 32c / 89f. The highest temp and it was rare was 35c / 95f. Do you think I'm safe or should I expect problems in the future? Some say that I can have HardDrive problems but I haven't
"yet".Your suggestion would be appreciated.

[This message has been edited by MagnumJoe (edited 04-10-99).]

[This message has been edited by MagnumJoe (edited 04-10-99).]

[cobain1crt]

no big deal, you are barely over 400

[WhoKnowsWho]

I don't think "barely being over 400" means much... some hard drives have problems, some don't, some require you to turn down the pio mode down a notch to work correctly. Just keep watch on your hd, and take note if you start losing chains or data. The you know you will have to either turn the pio mode down or lower the bus speed to 75mhz. Also, some sound cards and video cards don't like the 83 mhz bus speed much, but you seem to be having no probems with those, or heat, so you should be fine. Just keep an eye on that hd and back up stuff if you want to be really safe.