Need CDR-W help please..

[jamess]

Ok my problem is that I tried to install Win98SE on my computer Friday night and it messed my computer up first I had to reinstall almost all of the drivers and then I still didn't get it to work so finally I uninstalled the SE and now when I load my HP CDR-W software it says that it has loaded correctly and it needs to reboot. Well this is where the problems really start It boots up with a Fatal Exception Error 0E at 0028:00000009 in VXD ---. And the only way that I can get it to do anything is to go into Safe mode and uninstall the HP software and the computer will work alright. The CDR-W is showing up in windows and I can use it to run cd's like a regular cd-rom but I can't burn anything without the software. It was running fine before all of this and now I can't figure out what's causing this so that I can fix it. If anyone has any helpful suggestions or opinions please tell me so that I might can get this working again. Thanks for any help or advice.

[This message has been edited by jamess (edited 02-01-2000).]

[codybear]

when you say you uninstalled se what do you mean??

[ram]

I have 0 experience with win98/se,but from ive been reading on this MB i would not use it.I have Win95/B or osr2 and have found it to be the most stable of the windows.If you have more trouble just get rid of it and go to win95 IMOA.

[jamess]

I've ran the uninstall for Win98SE and also for the HP software. Every time I install the HP it comes up with that Fatal Exception blue screen.