Intel 500E Vcore for Iwill Slocket II

[Mattyb]

I have an Intel Pentuim III 500E FCPGA and an Iwill slocket II. I have the slocket set at 2.0 vcore. I am not sure if this is correct? Where would I go to verify, and could setting it to 2.0 cause any damage to the cpu if the correct Vcore is less or more than 2.0.

[blade_146]

Go HERE (http://www.azzo.com/products/slocket_ii.html) and check out the spec sheet for the slotket.


[This message has been edited by blade_146 (edited 01-14-2000).]

[Mattyb]

Auraedge, thanks! I hadn't ran system for to long so thangs hadn't got damaged (crossing fingers). I have everthing up and running and don't seem to have any ill affects. Is there any possible damage which I wouldn't notice? System is kicken now:

Antec case 250pw
Intel 500E FCPGA w/ Iwill socket II
256MB Pc 100/133 mhz
Viper II 32 MB Video card
SBlive MP3+
Maxtor Diamond 20gig ultra dma 66 7200rpm
Diamond suprasonic II 112k modem
Tyan tsunami 440BX ATX 100fsb mobo
Toshiba 8x2x32 DVD/CDRW/CDROM
DLink Network card 10/100mps ethernet
92mm 3pin Fan (Front case)
PC ISA slot Air Cool
Ls120 super disk

My dream machine http://www.sysopt.com/forum/smile.gif


Mattyb (thanks all!)

[AuraEdge]

The default for the Pentium III 'e' Processors is 1.60v. If you had set it to 2.0v and turned it on, you may have fried it. Good call on checking first. Any higher than 1.8v would be dangerous on a Pentium III 'e' Processor.