Evergreen Upgrade Problems

[Rich H]

Hi,

I have just purchased an Evergreen 333 upgrade (i.e K6-2 + fan) to speed up my faltering Pentium 133.

I followed the installation guide and flashed the BIOS (from AMI to MR BIOS) and installed the processor. Didn't need to make any adjustments as bus speed was already 66MHz. Now the system seems to bootup OK (can hear memory check) but theres no output to the screen.

Any suggestions? When I replace the original P-133 chip everything seems to be OK (except power light flashing on and off).

I know the chip needs 3.3-3.6 volts to make it work, but I don't know if my mobo is running at that as I don't have the manual to check and BIOS tells me nothing. Stupidly I forgot to note the AMIBIOS number so I can't check online.

The mobo info I have is:

BIOS CHIP: Flash N28F001 BXT120 U63083J1 ('90,'93)

INTEL PCI SET: SB82371SB L6345849 SU093

Any help will be GREATLY appreciated

[izzzy12k]

Without the original info, it's gonna be tough!

got any serial number info on the motherboard? (uaually a sticker or stamped)

-Izzzy12k

[Legoboy]

Look for the FCC ID number, it will be laid out like this:
xxx-xxxxxxxxxxxxxx

First 3 characters are the company code followed by a 14 digit product code. If you can find that and post it here, we'll be able to help.

Legoboy