Blanks in Sys Config Utility

[adl6009]

I was looking for something else but when I looked at the system configuration utility I noticed 5 lines that have no information under the Command and Location tabs. These 5 blank lines did have check marks under the first tab, Startup Item. What do you think these lines could be doing? Or why are they there? What will happen if I uncheck them ? If I uncheck them how do I get them back if the computer doesn't like it.
Thanks.

[adl6009]

I forgot to describe the system, sorry.

[Midknyte]

i normally uncheck them. I haven't found any of them to be "necessary". If it was legit, then it should announce what it is.

if anything, you can boot to safe mode and recheck them.

[adl6009]

I unchecked one and windows restarts with an error message, something about a selective startup mode and diagnostic utility and will restart like this every time unless I undo the change. Whats this? Did the change do something "bad"?

[Steve R Jones]

It will start like that (selective mode) BUT you will not see the warning box again unless you uncheck something.

[Train]

Check the bos, lower left, and it will disappear until you make changes in msconfig again.