Second hard drive not recognized on reboot

[peak]

I recently added a second hard drive. When I cold start, the second drive is recognized. When I "reboot", its not recognized... any suggestions?

[Excavator]

If your running win 95or98 you need to go to your control panel and add new hardware & follow the instuctions

[Axel]

did you go through set-up in your CMOS settings and identify the drive?

Did you jumper the drive to be 'slave' and make sure your primary HD is jumpered for 'Master' - probably not the problem, but worth checking.

Small chance it's your IDE cable, unless you have a SCSI set-up. If it's a SCSI, have you already used that drive number on your chain and is the chain properly terminated?

if you are using win95, and it's a larger drive over 2.1GB, did you install the disk overlays?

Have you ever used an EZ product when setting up the first drive? - Check other threads on this board for a fix on how to uninstall the EZ software.

Except for a broken drive, that's all that really comes to mind.