Strange Mobo

[XtremeMachine]

My mobo manual said it support Cele, PEN II, Pen III at 733EB or B. 133Mhz Bus clock. But I have a celeron and the mobo only have 100 & 133 FSB jumper, and RESERVE, or DISABLE(auto). I don't know what it's mean to set it as 66MHz bus. Because I set the jumper as 100Mhz then it keep beeping continuesly, and when I don't set it then there are no beeping" Nothing happen."Even if I put it as 133MHz FSB "Nothing Happen." Even tried RESERVE, or Disable.

Please Help. What can I do? HELP HELP HELP!!!

[Mntsnow]

What is the make and model of your motherboard?

Mntsnow

[Axel]

When you changed your bus speed - are you sure your RAM can handle the change? The beeping sounds like either your RAM isn't showing up on your system, or possibly, the system doesn't see any of your hard drives attached. Try reseating the IDE cables or SCSI card & cables to eliminate that - same with your floppy drive cable if that's first in your boot sequence. You may have just bumped a cable adjusting all of that other stuff on your board.

[socalgal]

I'm pretty sure this is a tie in to http://www.sysopt.com/forum/Forum2/HTML/003425.html