frank4
10-10-1999, 10:55 PM
I recently purchased a ISA 56k internal modem
There are no jumpers on the board. I am installing it on windows 3.1. I can't get the software to recognize the hardware. I turned off the com port in the BIOS etc. Interestingly, I installed 2 other old modems on the same computer (486dx66) using the same software, and with both, they autoconfigured nicely, and ran nicely. The modem is a PHOEBE ISA 56K\V90 .The software is Cheyenne Bitware.
Is the hardware defective, or is there something I'm overlooking?
There are no jumpers on the board. I am installing it on windows 3.1. I can't get the software to recognize the hardware. I turned off the com port in the BIOS etc. Interestingly, I installed 2 other old modems on the same computer (486dx66) using the same software, and with both, they autoconfigured nicely, and ran nicely. The modem is a PHOEBE ISA 56K\V90 .The software is Cheyenne Bitware.
Is the hardware defective, or is there something I'm overlooking?