using setk6v3

[nigel mcloughlin]

Can anyone give me some info on how to use this app? the readme is OK but it does'nt tell me how to go about it, install my k6-2 400,then reboot and then run set k6, or set k6 then install chip??

[Ricardo]

Well Nigel, first of all you must have the processor already installed and running.
Using Setk6 it´s easy, you ust go to DOS prompt(unnecessary to reboot)and type in the same directory where the programs is installed the following command:
setk6 /on /M0:LFB
This will install manually, if you need to automatize, do a .bat program with the commands above and put in the start folder.

Good Luck /forum/wink.gif

[LED]

In the C:\AUTOEXEC.BAT type in

Setk6d/on
Setk6d/on128M (Your amount of Memory)
SetK6d/MO:LFB,16MB (Video Memory amount)
setk6d/M1:LFB2,16M (Video Memory amount)

[This message has been edited by LED (edited 09-28-99).]

[nigel mcloughlin]

Thanks Guy's,
it's working a treat only one problem though I had to rem the line"setk6d/M1:lfb2" cos whenever I tried to start MS combat flt sim the screen went pale grey with a vertical red and a blue band on the left side. The sound was fine and it appear'd the game was running ok, but the only way to get out was to ctrl, alt, del and then the computer locked up. With this line rem'd all's ok. (sofar!!)

I have an 8 meg Matrox millenium2 and a 12meg 3d blaster voodoo2