K6-2-450 on ep-58MVP3C-M

[ettet]

Have just purchased a K6-2-450 to install on my ep-58MVP3C-M motherboard,the chip says to run at 2.4v but my board does not have a jumper for this setting,the EPOX site has a few more jumper settings,but not 2.4v.Is there any solution?.
Thanks in advance.
MIke

[natas]

Are you sure!I have 2 of the same models both with 2.4v.It is the 3 jumper going left to right.

[Mntsnow]

Here is your answer! (ripped from Epox's website)Bulletin #25: Additional core voltage options on selected MVP3 models

Last modified: 08/18/99
Article: t-25.html
This information applies to:

EP-58MVP3C-M
EP-51MVP3E-M
EP-51MVP3F-A
EP-MVP3G-M (REV below 1.0)
Question:

How can more core voltage options be used?

Answer:

On selected models further core voltage selections may be used even though no actual jumper option is listed. Two jumpers must be used to obtain additional voltages that are not listed in the documention or board surface. Listed below are these optional core voltage options that can be obtained. Not all models and board revisions will have jumpers for all core voltages listed below. Only use core voltages for which your processor (CPU) is rated for!

No voltage jumpers = 2.0v (approx.)
Jumper 2.1 and 2.2 = 2.3v (approx.)
Jumper 2.1 and 2.4 = 2.5v (approx.)
Jumper 2.2 and 2.4 = 2.6v (approx.)
Jumper 2.1 and 2.8 = 2.9v (approx.)
Jumper 2.2 and 2.9 = 3.1v (approx.)
Jumper 2.1 and 3.2 = 3.3v (approx.)
Jumper 2.2 and 3.2 = 3.4v (approx.)
Jumper 2.4 and 3.2 = 3.5v (approx.)


Mntsnow /forum/biggrin.gif



[This message has been edited by Mntsnow (edited 09-03-99).]