DIMM's...keep em both in?

[AuraEdge]

Wow..ok...Just got a new 128 stick to add to my 64 stick...been running it for about oh...10 minutes now...ALOT smoother
Anyways heres the Q
Sisoft Sandra says that I have a 128 DIMM 7ns PC100 CAS-3 in Bank 1 and a 64 DIMM 6ns PC66 CAS-2 in bank 2. Assuming this is all correct, and im runing my comp at 3.5x100 @ CAS-2, should I keep the 64 dimm in there (since its PC66)? Also, the 64 stick is ECC while the 128 is not (im running it disabled, seems to work fine even tho they have different number of bits...)
The 128 is a Seimens and the 64 is an IBM.

Ive tryed clocking with each one by itself... (to 112x3.5 @ CAS 3) It freezes up about 5 seconds into windows either way..I guess its not the Ram bottlenecking me. Wonder what it is

Thats my second question

I have a SBL!V in the PCI slot (at 1/3), a CL TNT in the AGP slot (at 2/3), and a 350 PII w/ retail fan/sink on a BH6.
Some of you people are pumpin 150 extra Mhz..and im trying to get 50 more and im going nuts! (PS runs ok at 100x3.5 w/ turbo)

Well..u dont hafta answer both Q's
Just tell me suggestions and add a bit to my knowledge



[This message has been edited by AuraEdge (edited 06-23-99).]

[LJE2]

You have not mentioned anything about raising the core voltage, try increasing it to 2.1 or 2.2 volts, and see if it boots, if it boots but is just not stable, go to 2.3v but don't go over that, I know some people will but with a retail fan I wouldn't, and try this with just the 128 M stick in set to CAS 3

[This message has been edited by LJE2 (edited 06-23-99).]