//flex table opened by JP
PDA

Click to See Complete Forum and Search --> : Boot Up Problem

JLPETERS
04-11-1999, 12:44 AM
I have a Octek Rhino 6 MB with a Intel Pentium 133 Processor, Intel 82430 FX chipset , Western Digital hard drive with 32 meg ram, Awards Bios. My problem is on bootup I get the msg floppy disk(s) fail (C0). I can't find that error code anywhere. I tried another cable, another drive that worked on another computer, with no luck. Is this a problem with the Bios, mother board or ram. Any suggestion or help will be appreciated.
hhieu
04-11-1999, 01:50 AM
It sounds like there's some wrong with the connection...Make sure you connect the cable right (the red side of the cable should be on the #1 pin side). And you wanna check the Bios setting too: the 3.5 Floppy Drive should be enable, not the 5.25 Japanese type
...assuming that the floppy drive and the cable are in good condition http://www.sysopt.com/forum/smile.gif
Good luck,