Caliver
04-05-1999, 10:29 PM
Hi, I had a beautiful Celeron 450A (OC)
on an Abit BH6, while using an AGP S3 VirgeGX2 with no problems.
2 months ago I bought an AGP Asus TNT (VideoIn/Out), and discovered something strange.
When I use the TNT, the boot-up screens would be corrupted with little dotted vertical lines... This occurs also in the CMOS setup, distorting the text quite badly.
I am able to boot Windows while using the standard PCI driver, while having screen corruption (bits of windows and mouse get left behind) - but when I install the TNT drivers, it refuses to boot into Windows.
The TNT card works fine on my cousins Asus P2B, my friend's super-7 mboard, and my colleague's BH6.
But I have swapped my BH6, and I have the exact same problem, even though the board has a different AGP connector (Tekcon, previously Molex) - (Originally I suspected the connector to have a design fault).
Anyone seen this problem before? Any info would be greatly appreciated!
Thanks!!
Caliver
on an Abit BH6, while using an AGP S3 VirgeGX2 with no problems.
2 months ago I bought an AGP Asus TNT (VideoIn/Out), and discovered something strange.
When I use the TNT, the boot-up screens would be corrupted with little dotted vertical lines... This occurs also in the CMOS setup, distorting the text quite badly.
I am able to boot Windows while using the standard PCI driver, while having screen corruption (bits of windows and mouse get left behind) - but when I install the TNT drivers, it refuses to boot into Windows.
The TNT card works fine on my cousins Asus P2B, my friend's super-7 mboard, and my colleague's BH6.
But I have swapped my BH6, and I have the exact same problem, even though the board has a different AGP connector (Tekcon, previously Molex) - (Originally I suspected the connector to have a design fault).
Anyone seen this problem before? Any info would be greatly appreciated!
Thanks!!
Caliver