//flex table opened by JP
PDA

Click to See Complete Forum and Search --> : Overclocking Problem

AdamST
04-12-2004, 12:26 PM
I used ATI tool and radlinker to get 410core and 365 memory. I set and save in ATI tool and i set and apply in radlinker, but whenever i restart i go back to default speeds.
Midknyte
04-12-2004, 02:33 PM
what make and model of card is it?

what about rivatuner?

http://downloads.guru3d.com/download.php?det=163
AdamST
04-12-2004, 03:54 PM
ATI Radeon 9800Pro
dajogejr
04-12-2004, 03:57 PM
Dumb question...but, did you check to make sure the "run settings at startup" was checked?
Also...

I believe RadClocker runs as a service...did you make sure it was set to run automatically at startup.

I use it...tweak mine just a little tad...and no problems at all...same card.
Bigjakkstaffa
04-12-2004, 06:23 PM
If memry serves, Radlinker uses Radclocker for its overclocking, which is what i use as a stand-alone. To set a new clock speed in Radclocker you have to Change the values using the sliders, press the 'Set' button, abd then, if you want to use this clock speed at all times, the 'Use Current' button, which will then tell the BIOS to always boot using the clock speeds you have just set

--Jakk:t