sli v2 3d blaster

[slickwilly]

I cant get my system to use my sli configuration. Sys is PII 300 with 128 sdram and matrox g200. The fps does not change when I take a voodoo 2 out of the system. Any ideas?
thanks

[balor]

are all your pci and isa slots filled? sometime on a share slot if all are filled on device may not work. Is your sli cable the right one or installed correctly. lastly have you tested each card indavidualy to make shure they are both good. not shure if this will help just some suggestions http://www.sysopt.com/forum/smile.gif

[BC_1]

Can you run at 1024x768? If you can, then your SLI is working perfectly. The reason why your fps don't change can be due to:

1. The benchmark you're running. Many may still be CPU limited (Quake2 is a good example) and your processor is still the bottleneck, not the V2.

2. You don't have VSYNC disabled in the V2 control panel and you're limited to the refresh rate set refresh rate.